Absolutely, yes. A Metal Scrap Baler is specifically designed to compress a wide variety of metal scraps into dense, manageable bales for efficient handling, transportation, and recycling.

The term "other metal scraps" implies moving beyond standard materials like light iron or steel turnings. 

Here’s a detailed breakdown of what's possible and what's important to consider:

Metals Commonly Processed by Scrap Balers:

Ferrous Metals:

Carbon Steel: The most common (car bodies, appliances, framing).

Cast Iron: Often baled separately due to its brittleness and value.

Stainless Steel: High-value material, often kept separate from carbon steel.

Non-Ferrous Metals: While non-ferrous balers are often specialized, many standard balers can handle them if kept separate.

Aluminum: Beverage cans, siding, extrusions, cast parts. Extremely common.

Copper: Wire, tubing, cuttings (high value, usually baled in smaller, denser bales).

Brass & Bronze: Shell casings, plumbing fixtures, valves.

Mixed/Light Scrap:

Mixed Low-Grade Scrap: Can include a combination of metals, often from demolition or industrial cleanouts, as long as they are not hazardous.

White Goods: Appliances like refrigerators, washers, and dryers are often flattened or pre-crushed and then baled.

Light Gauge Metals: Roofing sheets, siding, ductwork.

Key Factors to Consider:

While a baler can process many metals, you must consider these points for safety, efficiency, and bale quality:

Baler Type and Strength:

Horizontal Balers are the most common for scrap metal, using immense pressure (measured in tons) to compress metal in a chamber.

Shear/Baler Combos first cut or shear the material before baling, which is crucial for long, stringy, or bulky items (like rebar, beams, or whole appliances).

The baling force must be sufficient for the material. Baling thick, hard alloys requires more force than baling thin aluminum sheet.

Material Preparation:

Size Reduction: Large, bulky items (engine blocks, large pipes) may need to be cut or pre-crushed with a shear or grapple before baling.

Contaminants: Remove non-metallic items as much as possible (plastic, rubber, wood, fluids). Hazardous materials (gas tanks, closed containers, chemical drums) must never be baled.

Loose, Tangly Material: Shredded turnings or light-gauge bundles can be fed directly. Stringy materials (wire, cable) are better suited for specialized cable balers or shears.

Separation for Value and Quality:

The golden rule of recycling: Keep metals separate to maximize value. A bale of pure aluminum is worth significantly more than a bale of mixed metals.

Buyer Specifications: Scrap mills and recycling centers have strict specifications on bale density, size, and purity. Baling mixed metals together often results in a lower-grade, less valuable product and may be rejected.

Safety:

Explosion Risk: Never, ever bale sealed containers, pressure vessels, or items containing flammable liquids or gases. The compression can cause catastrophic explosions.

Feed Safety: Use proper feeding equipment (conveyors, grapples) and never manually push material into the chamber.

Conclusion:

Yes, you can press a vast array of "other metal scraps" with a Metal Scrap Baler—from aluminum cans and copper wire to stainless steel offcuts and shredded appliances. The critical steps are:

Classify and separate your metals.

Prepare the material (size reduction, decontamination).

Choose the right baler with sufficient force and features (like a pre-shear) for your specific scrap mix.

Always prioritize safety to prevent accidents and damage to the equipment.

By following these guidelines, baling is an extremely efficient and profitable way to handle diverse metal scrap streams.